现金捕鱼平台

  1. Home> News Center > Industry News

Article details

Common characteristics of pulverizers-energy saving and environmental protection for later reuse

豪刚机械 浏览量: 2018/9/19 9:31:53 Haogang Machinery Pageviews:

Common characteristics of pulverizers-energy saving and environmental protection for later reuse


Pulverizer—Using coal gangue and coal slag as additives and internal fuel for brick factories; using coal gangue and shale to produce standard bricks and hollow bricks has become a major measure in accordance with national policies and benefiting society. However, the smashing of these materials, especially the smashing of wet materials, has always been a problem that puzzled brick factories in their normal production.


After a long-term investigation, careful design and bold practice, we successfully developed and produced a practical new patented product-Haogang Two-stage Crusher, which can easily crush high-humidity coal gangue, shale, cinder and other materials.

1. Two rotors crushing up and down

The two sets of rotors connected in series make the material crushed by the upper rotor immediately crushed by the hammer head of the lower rotor that rotates rapidly, and the inner cavity materials collide with each other rapidly and smash each other to achieve the effect of hammer powder and powder. Unload it directly.

2. No sieve bottom and high-humidity material, never block

The traditional pulverizer with a sieve plate is not suitable for raw materials with a moisture content higher than 8%. When the moisture content of the raw material is higher than 10%, serious blockage is extremely likely to occur, preventing the hammer head from turning, the material cannot be discharged, and even burned. Bad motors seriously affect production.

No sieve bottom, high-hard material, high-humidity material, to ensure that it will never be blocked, the feed moisture content can reach 100%, and the water discharge fineness 90% is all in 2MM (less than millimeter) 1MM (less than millimeter) accounts for 70% , Wet and dry, production as usual in rainy days.

The design of the machine has no sieve bottom and no strict requirements on the moisture content of the material. There is no problem of blocking the sieve plate, and there is no problem of fine powder that cannot be discharged in time and repeated crushing. Therefore, the crushing efficiency is high and there is no hammer. Ineffective wear.

3. Double-rotor two-stage crushing, large output, output granularity below 3㎜, more than 80%

4, wear-resistant combination hammer

High alloy wear-resistant hammer head. The hammer head and hammer handle are used in combination, only the hammer head is changed, and the hammer handle is not changed.

5.Unique shift gap adjustment technology

The hammer head does not need to be repaired after it is worn. It can be used repeatedly in a moving position. One hammer head can be used with three hammer heads.

6.Hydraulic manual start casing

It only needs one person to open and close easily. It is light, fast, safe and reliable, and easy to repair.


contact us

QR code

Sweep, there are surprises!

九五至尊网站是多少 电玩城游戏大厅 电子捕鱼平台 网上棋牌手游大全 上游棋牌大厅下载 胜博发娱乐游戏 棋牌游戏中心下载 中文电子游戏官网 最火的捕鱼游戏 龙8手机客户端